Plane crash map Locate crash sites, wreckage and more

N7109G accident description

Alabama map... Alabama list
Crash location 33.415000°N, 87.143611°W
Reported location is a long distance from the NTSB's reported nearest city. This often means that the location has a typo, or is incorrect.
Nearest city Bessemer, AL
33.401777°N, 86.954437°W
10.9 miles away
Tail number N7109G
Accident date 02 Feb 2007
Aircraft type Cessna 172K
Additional details: None

NTSB Factual Report

HISTORY OF FLIGHT

On February 2, 2007, approximately 0800 Central Standard Time, a Cessna 172K, N7109G, registered to and operated by the pilot, was destroyed when it collided with a mountain ridge near Bessemer, Alabama. Instrument meteorological conditions prevailed at the time of the accident. The personal flight was being conducted under the provisions of Title 14 CFR Part 91 without a flight plan. The commercial pilot and passenger were killed. The flight originated from Hornersville Memorial Airport, Hornersville, Missouri, approximately 0600, and was en route to Troy, Alabama.

According to Birmingham Approach Control, the airplane was transmitting on a VFR transponder code of 1200, and was heading in a southerly direction at an altitude of 1,100 feet. The pilot was not in radio communication with controllers. The airplane began a descent and made a turn to the north. Radar contact was lost at an altitude of 900 feet. On February 4, 2007, a family member contacted the Federal Aviation Administration (FAA) and reported that the airplane was overdue at its destination. An Alert Notice (ALNOT) was issued for the missing airplane and the Civil Air Patrol (CAP) was notified. On February 5, 2007, at 1345, CAP located the wreckage on a mountain ridge 11 miles west of Bessemer, Alabama. At 1600, the Jefferson County Sheriff's Department search and rescue (SAR) team arrived at the accident site and made positive identification of the airplane.

PERSONNEL INFORMATION

According to FAA documents, the 63-year-old pilot held a commercial pilot certificate with an airplane single-engine land rating, dated March 31, 2003. He was not instrument rated. His pilot certificate contained the restriction, "Carrying passengers in airplanes for hire is prohibited at night and on cross-country flights of more than 50 nautical miles." The pilot also held a second-class medical certificate, dated April 21, 2006, with a limitation for corrective lenses. FAA records revealed that the pilot had a total flight time of 7,000 hours. The pilot's logbooks were not recovered for review.

AIRCRAFT INFORMATION

The airplane was manufactured by the Cessna Aircraft Company in 1970. It was equipped with a Lycoming O-320-E2D engine, rated at 150 horsepower, driving a McCauley 2-blade, all-metal, fixed-pitch propeller.

Maintenance records indicated the engine had accrued 2,493.7 total hours since a major overhaul. Lycoming recommends 2,000 hours time-between-overhaul, and if the engine does not accumulate the hourly period of time between overhauls as specified, the recommended overhaul is in the 12th year.

METEOROLOGICAL INFORMATION

The following weather observation was recorded 0810 at Alabaster (EET), Alabama, approximately 25 nautical miles southeast of the accident site: wind, 310 degrees at 7 knots; visibility, 4 statute miles, light rain, mist; ceiling, 500 feet overcast; temperature, 4 degrees Celsius (C); dew point, 4 degrees C; altimeter, 29.86 inches of mercury; remarks, rain began 2 minutes past the hour; ceiling, 200 feet variable 800 feet.

WRECKAGE AND IMPACT INFORMATION

The accident site was at a location of 33 degrees, 24.9' North latitude, and 87 degrees, 8.607' West longitude, and at an elevation of 644 feet. The airplane made ground impact at an approximately 45 degree nose-down angle on a magnetic heading of 340 degrees. The wreckage path was approximately 120 feet long. The accident site was in a heavily wooded area near Mud Creek and Groundhog Roads. All components of the airplane were located at the accident site.

The propeller was separated from the engine. The descending blade had forward bending at the tip, aft bending mid-span, leading and trailing edge damage, and chord- and span-wise scoring. The ascending blade had variable bending and twisting, leading and trailing edge damage, and chord- and span-wise scoring.

The engine remained attached to the airframe but was compressed against the firewall. The throttle control was in the idle position, and the mixture control was in the full rich position. The carburetor heat control was in the mid-range position. The fuel selector was in the both position, and the ports were unobstructed. Residual fuel was found in the wing tanks and selector valve. There was no fuel in the carburetor. A post-accident partial disassembly of the engine revealed drive train continuity. All four cylinders produced compression when the engine was rotated.

The cockpit and the cabin section of the airplane were buckled. The instrument panel was destroyed. The nose gear was separated from the firewall and located along the debris path.

The right aileron bellcrank was wrapped around a tree near the initial tree strike. The aileron push/pull rod remained attached to the bellcrank and a portion of the aileron. The aileron cables remained attached to the bellcrank and the cable ends were separated. The remainder of the right wing was forward of the section found in the tree. A portion of the leading edge of the right wing was wrapped around a tree and crushed. A portion of the aileron remained attached to the wing and the second portion of the aileron separated from the wing. The flap remained partially attached and the flap actuator indicated the retracted position. The flap actuator attachment had separated from the wing and the actuator was free to move. The other end of the actuator remained attached to the flap bellcrank. The flap push/pull rod remained attached to the bellcrank and the flap. The flap cables remained attached to the bellcrank and were separated and had indications of overload. The right wing tank was breached and approximately one gallon of fuel was drained from the right wing tank. The fuel tested negative for water using water-finding paste. The right fuel cap was locked in place and the fuel cap was vented.

The left wing was located with the main wreckage. The aileron remained attached to the wing and aileron control cable continuity was established. The inboard flap track remained attached and the outboard flap track was not observed. The right flap push/pull rod remained attached to the bellcrank and the flap. The flap cables remained attached to the bellcrank and were separated with indications of overload. The left wing fuel tank had separated from the wing. The tank was breached and approximately four gallons of fuel were drained from the tank. The fuel observed in the tank tested negative for water using water-finding paste. The left fuel cap was locked in place and the fuel cap was vented.

The rudder remained attached and the rudder balance weight separated and was observed along the wreckage path. Rudder cable continuity was established from the rudder surface to the rudder pedals.

The left horizontal stabilizer and elevator remained attached. The inboard portion of the right elevator remained attached and the remainder was separated. The right elevator torque tube was partially broken. The elevator trim actuator remained attached and the elevator tab was separated. The elevator trim actuator chains were broken. Elevator trim cable continuity was established from the tailcone to the cockpit area.

The aileron cables were observed in the cockpit area at the control yoke and were separated with indications of overload.

MEDICAL AND PATHOLOGICAL INFORMATION

Postmortem examinations of the pilot and passenger were performed by the Jefferson County, Alabama Coroner/Medical Examiner Office. The cause of death for the pilot was listed as, "Blunt Force Trauma" and the manner of death was listed as, "Accident." The cause of death for the passenger was listed as, "Blunt Trauma" and the manner of death was listed as, "Accident."

Forensic toxicology was performed on specimens of the pilot and passenger by the FAA Bioaeronautical Sciences Research Laboratory (CAMI), Oklahoma City, Oklahoma. The CAMI toxicology reports were negative for carbon monoxide, cyanide, and ethanol, and drugs.

NTSB Probable Cause

The non-instrument-rated pilot's continued visual flight rules flight into instrument meteorological conditions.

© 2009-2020 Lee C. Baker / Crosswind Software, LLC. For informational purposes only.