Plane crash map Locate crash sites, wreckage and more

N227BC accident description

Georgia map... Georgia list
Crash location 33.631111°N, 85.151944°W
Nearest city Carrollton, GA
33.580110°N, 85.076611°W
5.6 miles away
Tail number N227BC
Accident date 17 Mar 2003
Aircraft type Beech A100
Additional details: None

NTSB Factual Report

On March 17, 2003, at 1825 eastern standard time, a Beech A100, N227BC, registered to and operated by CB Aviation Inc., collided with the ground when the nose wheel collapsed during landing on runway 34 at West Georgia Regional Airport in Carrollton, Georgia. The personal flight operated under the provisions of Title 14 CFR Part 91 with an instrument flight plan filed. Instrument weather conditions prevailed at the time of the accident. The airplane sustained substantial damage, and the pilot and passenger were not injured. The flight departed Minden, Louisiana on March 17, 2003 at 1600.

The flight made a stop at Mc Ghee Tyson Airport (TYS), Alcoa, Tennessee to drop off some non-revenue passengers. Upon landing at TYS the pilot noticed that the wing flaps were stuck in the down position. The pilot taxied the airplane to Vol Aircraft Maintenance to inspect the flaps. Vol Aircraft Maintenance informed the pilot that the flap motor was inoperative. Upon the pilot's request, the wing flaps were secured in the up position so the pilot may continue the flight to her destination.

The pilot departed Alcoa, Tennessee, with the flaps of the airplane secured in the up position. The wing flap circuit breaker was also disabled before the flight. The airplane was being repositioned from Alcoa, Tennessee to Carrollton, Georgia, with a passenger on board. The airplane did not have a ferry permit or a minimum equipment list to allow for flight with inoperative wing flaps.

According to the pilot she had completed one previous instrument approach that concluded in a missed approach. During the second approach to land, the pilot reported a mechanical problem with the wing flaps to the air traffic controller. The pilot elected to execute a flaps-up landing. During the landing rollout, the airplane rolled off the departure end of the runway 34 into a muddy area. The airplane nosed over and the nose gear collapsed.

The runway at West Georgia Regional Airport is 5,001 feet long. The airplane landed on the first third of the runway. At the time of landing runway 34 was wet and there was percipitation in the area. The airplane hydroplaned down the runway. The pilot stated "She applied reverse thrust upon landing". According to the Beech A100 Airplane Flight Manual, the flap up landing distance on dry asphalt, without propeller reversing is approximately 2200 feet of ground roll.

The Safety Information Section of the Pilots Opoerating Hadbook states "Use caution when landing on runways covered by water or slush which cause hydroplaning, a phenomenon that renders breaking and steering ineffective because of the lack of sufficient surface friction". Examination of the airplane revealed that the propeller assemblies were damaged. Both engines were also damaged.

The pilot stated that she did not compute the landing roll distance needed for landing on the wet runway.

NTSB Probable Cause

The pilot misjudged the approach and touchdown airspeeds that resulted in the overrun of the runway during a landing. Factors were the wet runway and hydroplaning conditions.

© 2009-2020 Lee C. Baker / Crosswind Software, LLC. For informational purposes only.