Plane crash map Locate crash sites, wreckage and more

N776JM accident description

Pennsylvania map... Pennsylvania list
Crash location 41.250556°N, 75.219167°W
Nearest city Canadensis, PA
41.192035°N, 75.251292°W
4.4 miles away
Tail number N776JM
Accident date 27 Mar 2016
Aircraft type Robinson R44
Additional details: None

NTSB Factual Report

HISTORY OF FLIGHT

On March 27, 2016, at 1147 eastern daylight time, a Robinson Helicopter R44, N776JM, was destroyed when it impacted terrain near Canadensis, Pennsylvania. The private pilot was fatally injured. The helicopter was registered to Sea Air Inc. and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91. Instrument meteorological conditions (IMC) prevailed, and no flight plan was filed for the personal flight. The flight departed Doylestown Airport (DYL), Doylestown, Pennsylvania, at 1109, destined for Mountain Bay Airpark (PA49), Greentown, Pennsylvania, about 60 miles to the north.

About the time of the accident, a witness was outside his home about 1/2-mile northwest of the accident site when he heard an aircraft engine overhead. The witness looked upward toward the sound, but the aircraft was obscured by clouds. He estimated the cloud height to be about 200 ft above the trees in his yard. The witness then heard a loud "boom," similar to a car striking a tree, followed by another "boom" a few seconds later.

The helicopter was equipped with an on-board GPS; review of the recorded data revealed that, over the last 10 minutes of flight, the helicopter's altitude gradually increased. The increase in altitude corresponded with rising terrain. As the helicopter approached the crest of a ridge, the GPS altitude increased sharply to about 2,200 ft mean sea level (msl), or about 200-300 ft above ground level (agl) in the area of the ridge. At the time, the reported cloud ceiling was also about 2,200 ft msl. The yellow arrows in Figures 1 and 2 indicate the climb and location of the ridge.

The helicopter then descended slightly as it began a left 330° turn, then climbed again; the GPS altitude indicated that the helicopter was above the cloud ceiling (as depicted by the yellow data points in Figure 2). The helicopter then flew northwest for about 40 seconds as it continued to climb, while the ground speed decreased from about 70 knots to about 20 knots. The helicopter then reversed course briefly, and then made several changes in track direction and altitude, before making a left 270° turn just before the last data point, which was about 135 ft north of the accident site at a GPS altitude of 2,678 ft msl, which was about 800 ft agl.

PERSONNEL INFORMATION

According to Federal Aviation Administration (FAA) records, the pilot held a private pilot certificate with ratings for airplane single-engine land, rotorcraft helicopter, and instrument airplane. His most recent FAA third-class medical certificate was issued March 10, 2016. A review of the pilot's logbooks revealed that he had a total of 2,333 hours of flight experience, including 449 hours in rotorcraft, of which 345 hours were in the same make and model as the accident helicopter. He had logged 7 hours in the 3 months before the accident, 5 of which were in the accident helicopter. In the 24 months preceding the accident, he had flown from DYL to PA49 17 times in the accident helicopter and 7 times in his airplane. He had not logged any flight experience in actual or simulated instrument meteorological conditions during that period.

AIRCRAFT INFORMATION

The four-seat, single-main-rotor, single-engine helicopter, serial number 1738, was manufactured in 2007. The helicopter was powered by a 260-horsepower Lycoming O-540-F1B5 series engine. The helicopter was not certificated for instrument flight rules operation.

Review of maintenance records revealed that the most recent 100-hour inspection was completed on July 1, 2015. At the time of the inspection, the airframe and engine had been operated for about 629 hours since new. The helicopter's total time on the day of the accident could not be determined due to impact and fire damage; however, the pilot had logged about 34 hours in the helicopter since the inspection.

METEOROLOGICAL INFORMATION

The closest reporting weather station to the accident site, Pocono Mountains Municipal Airport, Mount Pocono, Pennsylvania, was located about 10 miles southwest of the accident site at an elevation of 1,915 ft. At 1153, the reported weather included an overcast ceiling at 300 ft agl with 7 statute miles of visibility. The wind was from 140° at 7 knots, the temperature was 4°C, the dew point was 3°C, and the altimeter setting was 30.31 inches of mercury. The station reported an overcast ceiling height of 200 ft agl from 0953 to 1118.

A weather computer model balloon sounding and satellite weather data for the accident area about 1100 showed clouds likely from near the surface through 4,000 ft msl. Weather radar animation for the accident area at the time of the accident showed no precipitation.

The area forecast issued at 0445 and valid at the time of the helicopter's departure forecasted an overcast ceiling between 1,500 and 2,000 ft msl with cloud tops between 3,000 and 4,000 ft msl. However, the 0445 area forecast showed cloud ceiling conditions improving between 0800 and 1100, with the forecast expecting broken to scattered clouds between 1,500 and 2,500 ft msl. The forecast showed continued improving conditions between 1100 and 1400, with scattered clouds at 2,500 ft msl, a broken ceiling between 3,500 and 5,000 ft msl, and cloud tops at 6,000 ft msl.

Between 0827 and 1045 a separate AIRMET was in effect for the accident area; it warned of mountain obscuration and IFR conditions due to clouds, fog, and mist along the flight route and at the accident site. An AIRMET issued at 1045 indicated mountain obscuration along the flight route due to clouds, precipitation, and mist was in effect for the accident area at the time of the accident.

The weather conditions reported at DYL at an elevation of 394 ft msl, at 1054, which was about 15 minutes before the pilot departed were: variable wind at 3 knots, 10 statute miles visibility, an overcast ceiling at 1,700 ft agl, temperature 7°C, dew point 4°C.

According to the pilot's son, who was also a pilot, he had reviewed the weather conditions and forecast with the pilot on the morning of the accident. They were both aware of the low ceilings and forecast of improving conditions. They were satisfied that the conditions should be suitable for the flight. The pilot did not receive a weather briefing from a flight service station.

FLIGHT RECORDERS

The helicopter was not equipped with a flight recorder nor was it required to be. A portable GPS receiver was recovered from the accident site and forwarded to the NTSB Vehicle Recorder laboratory for examination. It captured GPS position and time data for the accident flight and several previous flights. More information is available in the public docket for this investigation.

WRECKAGE AND IMPACT INFORMATION

The helicopter impacted a wooded area about 100 yards north of an east-west oriented ridgeline, about 20 ft below the top of the ridge at an elevation of 2,000 ft msl. The wreckage path proceeded downhill along a heading of about 325° magnetic and was about 175 ft long. All major components of the helicopter were located at the accident site. The wreckage was significantly fragmented and partially consumed by a postcrash fire. Continuity from the controls to the main and tail rotor systems could not be confirmed due to impact and fire damage, however, all control rod ends were found in the wreckage path.

The throttle control linkages sustained impact and thermal damage. The linkage on the collective pitch control assembly was found in the full open position. The rod end at the carburetor control arm was fractured. The control arm was found beyond the full open position and the arm stop was separated from the carburetor. The mixture control knob and the control cable end (separated from the control arm) were found in the full rich position. The carburetor heat control linkage and slider valve were found in the on position.

The empennage, tail rotor gearbox, and one tail rotor blade that was fractured near its root, were among the debris found closest to the initial impact area. The tail rotor gearbox rotated freely by hand. Both tail rotor blades exhibited leaded edge gouging. The engine, main rotor gearbox, and tailboom, were all separated from the fuselage and located along the wreckage path. The main rotor driveshaft was fracture-separated at the main rotor hub, consistent with overload. The driveshaft rotated freely by hand. Both main rotor blades remained attached to the hub and were significantly damaged by impact and fire. The fuselage components were fragmented and thermally damaged. All of the cockpit flight controls were found in the debris.

Examination of the engine revealed fire and impact damage. The crankshaft was rotated by hand, and continuity was confirmed from the powertrain through the valvetrain to the accessory section. Valve continuity to the number 5 cylinder could not be confirmed due to impact damage to each pushrod. Compression was confirmed in all cylinders using thumb compression. Both magnetos were damaged by impact and fire and could not be actuated to produce spark. The spark plugs were intact and appeared consistent with the "worn out – normal" depiction on the Champion Check-A-Plug chart.

MEDICAL AND PATHOLOGICAL INFORMATION

Forensic Pathology Associates, Allentown, Pennsylvania, conducted an autopsy on the pilot. The cause of death was determined to be "multiple blunt force injuries."

The FAA Bioaeronautical Sciences Research Laboratory, Oklahoma City, Oklahoma, conducted toxicological testing of specimens from the pilot. The results were positive for diltiazem and metoprolol, which are used to control blood pressure. Neither are considered to be impairing and the pilot had reported them during his most recent medical exam. The results were positive for ethanol that was consistent with postmortem production.

The pilot's family reported that on the morning of the accident, the pilot woke up dizzy with an elevated heart rate, but he felt well before the flight.

ADDITIONAL INFORMATION

Spatial Disorientation

The FAA Civil Aeromedical Institute's publication, "Introduction to Aviation Physiology," defines spatial disorientation as a loss of proper bearings or a state of mental confusion as to position, location, or movement relative to the position of the earth. Factors contributing to spatial disorientation include changes in acceleration, flight in IMC, frequent transfer between visual meteorological conditions (VMC) and IMC, and unperceived changes in aircraft attitude. The publication states that pilots flying in IMC are more susceptible than usual to the stresses of flight, such as fatigue and anxiety, and any event that produces an emotional upset is likely to disrupt the pilot's mental processes, making them more vulnerable to illusions and false sensations.

The FAA's Airplane Flying Handbook (FAA-H-8083-3A) describes some hazards associated with flying when the ground or horizon are obscured. The handbook states, in part: "The vestibular sense (motion sensing by the inner ear) in particular tends to confuse the pilot. Because of inertia, the sensory areas of the inner ear cannot detect slight changes in the attitude of the airplane, nor can they accurately sense attitude changes that occur at a uniform rate over a period of time. On the other hand, false sensations are often generated; leading the pilot to believe the attitude of the airplane has changed when in fact, it has not. These false sensations result in the pilot experiencing spatial disorientation."

NTSB Probable Cause

The pilot's loss of control due to spatial disorientation, which occurred after ascending in order to clear rising terrain and inadvertently entering the clouds.

© 2009-2020 Lee C. Baker / Crosswind Software, LLC. For informational purposes only.